/*
 * The MySensors Arduino library handles the wireless radio link and protocol
 * between your home built sensors/actuators and HA controller of choice.
 * The sensors forms a self healing radio network with optional repeaters. Each
 * repeater and gateway builds a routing tables in EEPROM which keeps track of the
 * network topology allowing messages to be routed to nodes.
 *
 * Created by Henrik Ekblad <henrik.ekblad@mysensors.org>
 * Copyright (C) 2013-2019 Sensnology AB
 * Full contributor list: https://github.com/mysensors/MySensors/graphs/contributors
 *
 * Documentation: http://www.mysensors.org
 * Support Forum: http://forum.mysensors.org
 *
 * This program is free software; you can redistribute it and/or
 * modify it under the terms of the GNU General Public License
 * version 2 as published by the Free Software Foundation.
 *
 *******************************
 *
 * DESCRIPTION
 *
 * Vibration Sensor
 *
 * connect the sensor as follows :
 *
 * VCC       >>> 5V
 * S         >>> D3
 * GND       >>> GND
 *
 * Based on: http://www.dfrobot.com/wiki/index.php/DFRobot_Digital_Vibration_Sensor_V2_SKU:DFR0027
 * Contributor: epierre
 */

// Enable debug prints to serial monitor
#define MY_DEBUG

// Enable and select radio type attached
#define MY_RADIO_RF24
//#define MY_RADIO_NRF5_ESB
//#define MY_RADIO_RFM69
//#define MY_RADIO_RFM95

#include <MySensors.h>
#include <Wire.h>

#define CHILD_ID_VIBRATION 0
#define VIBRATION_SENSOR_DIGITAL_PIN 3
#define SensorLED     13

uint32_t SLEEP_TIME = 10*1000; // Sleep time between reads (in seconds)

//VARIABLES
int val = 0;           // variable to store the value coming from the sensor
float valVIBRATION =0.0;
float lastVIBRATION =0.0;
unsigned char state = 0;

MyMessage vibrationMsg(CHILD_ID_VIBRATION, V_LEVEL);

void setup()
{
	pinMode(VIBRATION_SENSOR_DIGITAL_PIN, INPUT);
	attachInterrupt(digitalPinToInterrupt(VIBRATION_SENSOR_DIGITAL_PIN), blink,
	                FALLING); // Trigger the blink function when the falling edge is detected
	pinMode(SensorLED, OUTPUT);
}

void presentation()
{
	// Send the sketch version information to the gateway and Controller
	sendSketchInfo("VIBRATION Sensor", "1.0");

	// Register all sensors to gateway (they will be created as child devices)
	present(CHILD_ID_VIBRATION, S_VIBRATION);
}

void loop()
{

	if(state>=40) { // basically below 40 so ignire basic level
		send(vibrationMsg.set(int16_t(state)));
		state = 0;
		digitalWrite(SensorLED,HIGH);
	}    else {
		state = 0;
		digitalWrite(SensorLED,LOW);
	}


	// Power down the radio.  Note that the radio will get powered back up
	// on the next write() call.
	delay(1000); //delay to allow serial to fully print before sleep

	sleep(SLEEP_TIME); //sleep for: sleepTime
}

void blink()//Interrupts function
{
	state++;
}